Hey everyone, hope you are well! I am here with a Vintage butterfly wings 3D display. I used an image of butterfly wings from a vintage book found on the graphics fairy site. I printed it twice so I could use a layer for 3D wings.
I carefully cut out just the wings from one of the printed sheets and then to make them appear like real butterfly wings I shaped them with a curve and attached 3D foam pads on the outer edges of the outside of the wing. I then dipped the inside of the wing in pva then placed them on the other printed sheet. That way the wing curves up like its real.
I mounted onto a sheet of cardstock covered with cotton and then placed in a box frame.
I would like to enter this into the following challenges:
Crafting with an Attitude: Anything Goes
Crafty Girls Creations: Anything Goes
Cute Cards Tuesday: Anything But a Card
Southern Girls Challenge: Pop it Up
Crafty Gals Corner Challenge: Anything But a Card
Crafting By Designs: Anything Goes
Creative Moments: Anything Goes
Thank you for looking and for all your lovely comments!
Ohh my this is absolutely beautiful x
ReplyDeleteWow, looks like real butterflies. Beautiful colours. Thanks for sharing with us at Southern Girls Challenge, we hope you will join us again soon. Meighan DT
ReplyDelete